Anysecu WP-9900 programming software
Open WebCHIRPWebCHIRP programs the Anysecu WP-9900 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Anysecu programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the WP-9900
- 200 memory channels, numbered 0 to 199
- Channel names up to 7 characters
- Transmit power: High 25W, Low 5.0W
- Modes: FM, NFM
- Bands: 130–180 MHz, 400–521.05 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
WP-9900 hardware
Researched from the sources listed below — spec sheets, manuals and retailer listings — rather than taken from the CHIRP driver. Anything not established is left out.
| Type | Mobile |
|---|---|
| Transmit power | Up to 25 W |
| Modulation | FM |
| Display | Yes |
| Dual receive | No |
| Cross-band repeater | No |
| APRS | No |
| GPS | No |
| Bluetooth programming | No |
Frequency bands
| Band | Receive | Transmit |
|---|---|---|
| VHF | 136–174 MHz | 136–174 MHz |
| UHF | 400–480 MHz | 400–480 MHz |
25 W VHF / 20 W UHF, high/low switchable. Tri display and standby, not simultaneous receive.
Sources: szanysecu.com · cqradiouk.co.uk
How to program a Anysecu WP-9900
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Anysecu WP-9900 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Anysecu WP-9900?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Anysecu CPS software?
No. WebCHIRP runs CHIRP's own Anysecu WP-9900 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Anysecu WP-9900 hold?
200, numbered 0 to 199 in the channel table.