Anysecu UV-A37 programming software
Open WebCHIRPWebCHIRP programs the Anysecu UV-A37 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Anysecu programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the UV-A37
- 256 memory channels, numbered 1 to 256
- Channel names up to 12 characters
- Transmit power: H 5.0W, L 1.0W
- Modes: FM, NFM
- Bands: 108–136 MHz, 136–174 MHz, 200–260 MHz, 350–390 MHz, 400–520 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
UV-A37 hardware
Researched from the sources listed below — spec sheets, manuals and retailer listings — rather than taken from the CHIRP driver. Anything not established is left out.
| Type | Handheld |
|---|---|
| Charging | USB-C, Desktop charging cradle |
| Transmit power | Up to 5 W |
| Modulation | FM, AM, WFM |
| Display | Yes |
| Dual receive | No |
| Cross-band repeater | No |
| APRS | No |
| GPS | No |
| Bluetooth programming | No |
Frequency bands
| Band | Receive | Transmit |
|---|---|---|
| FM broadcast | 66–108 MHz | — |
| Airband | 108–136 MHz | — |
| VHF | 136–174 MHz | 136–174 MHz |
| Other | 200–260 MHz | 200–260 MHz |
| Other | 350–400 MHz | 350–400 MHz |
| UHF | 400–520 MHz | 400–520 MHz |
Sold as a rebadged Abbree AR-730, whose listings give 220–260/350–390 MHz. A 2000 mAh battery is claimed; an AR-730 review measured about 1030 mAh.
Sources: szanysecu.com · besthamradio.com · chirpmyradio.com · alibaba.com
How to program a Anysecu UV-A37
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Anysecu UV-A37 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Anysecu UV-A37?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Anysecu CPS software?
No. WebCHIRP runs CHIRP's own Anysecu UV-A37 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Anysecu UV-A37 hold?
256, numbered 1 to 256 in the channel table.