TYT TH-350 programming software
Open WebCHIRPWebCHIRP programs the TYT TH-350 in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
TYT programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the TH-350
- 128 memory channels, numbered 1 to 128
- Channel names up to 5 characters
- Transmit power: Low 1.0W, High 5.0W
- Modes: FM, NFM
- Bands: 130–175 MHz, 220–269 MHz, 400–520 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
TH-350 hardware
Researched from the sources listed below — spec sheets, manuals and retailer listings — rather than taken from the CHIRP driver. Anything not established is left out.
| Type | Handheld |
|---|---|
| Battery | 1600 mAh |
| Charging | Desktop charging cradle |
| Transmit power | Up to 5 W |
| Modulation | FM |
| Display | Yes |
| Dual receive | No |
| APRS | No |
| GPS | No |
| Bluetooth programming | No |
Frequency bands
| Band | Receive | Transmit |
|---|---|---|
| 2 m | 136–174 MHz | 136–174 MHz |
| 1.25 m | 220–260 MHz | 220–260 MHz |
| 70 cm | 400–480 MHz | 400–480 MHz |
Export ranges from retailers; US units are sold for the 2 m / 1.25 m / 70 cm ham bands and TYT publishes no US TX limits. Tri-standby is scanning, not three receivers.
Sources: rigreference.com · tyt888.com · hi-radio.com
Which TH-350 do you have?
CHIRP has 2 drivers for the TYT TH-350, covering different firmware and production runs. The figures above are the TH-350 (stock); open yours directly if it is one of the others.
- TH-350 (stock) — 128 channels, names up to 5 characters
- TH-350 (US) — 128 channels, names up to 8 characters
How to program a TYT TH-350
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check TYT TH-350 is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the TYT TH-350?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the TYT CPS software?
No. WebCHIRP runs CHIRP's own TYT TH-350 driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the TYT TH-350 hold?
128, numbered 1 to 128 in the channel table.