Jetstream JT270MH programming software
Open WebCHIRPWebCHIRP programs the Jetstream JT270MH in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Jetstream programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the JT270MH
- 99 memory channels, numbered 1 to 99
- Channel names up to 7 characters
- Transmit power: Low 5.0W, Mid 10W, High 25W
- Modes: FM, NFM
- Bands: 136–174 MHz, 400–480 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
JT270MH hardware
Researched from the sources listed below — spec sheets, manuals and retailer listings — rather than taken from the CHIRP driver. Anything not established is left out.
| Type | Mobile |
|---|---|
| Transmit power | Up to 25 W |
| Display | Yes |
| Still manufactured | No |
| APRS | No |
| GPS | No |
| Bluetooth programming | No |
Frequency bands
| Band | Receive | Transmit |
|---|---|---|
| 2 m | — | 144–148 MHz |
| 70 cm | — | 430–450 MHz |
25 W version of the JT-270M (Leixen VV-898S family). TX ranges are from listings; receive ranges are not published. The 10 W JT-270M is dual watch only.
Sources: batteriesamerica.com · ebay.com
Can I update the firmware on the JT270MH?
Jetstream publishes no firmware update for the JT270MH: its radios are programmed at the factory, and their firmware is not meant to be replaced. Jetstream radios are built by Leixen.
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Jetstream JT270MH
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Jetstream JT270MH is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Jetstream JT270MH?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Jetstream CPS software?
No. WebCHIRP runs CHIRP's own Jetstream JT270MH driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Jetstream JT270MH hold?
99, numbered 1 to 99 in the channel table.
Can I update the firmware on the Jetstream JT270MH?
Jetstream publishes no firmware update for the JT270MH: its radios are programmed at the factory, and their firmware is not meant to be replaced. Jetstream radios are built by Leixen. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.