Baofeng GM-15Pro programming software
Open WebCHIRPWebCHIRP programs the Baofeng GM-15Pro in your browser. It runs the CHIRP project's own driver for this radio, so it reads and writes the same codeplug the desktop software does — without installing anything.
No driver install needed
Baofeng programming cables use a CH340, CP2102, PL2303 or FTDI USB-serial chip. WebCHIRP speaks to all four directly from the browser, so there is no driver package to download and no Windows version to match. Plug the cable in and pick the port when the browser asks.
What you can edit on the GM-15Pro
- 250 memory channels, numbered 1 to 250
- Channel names up to 6 characters
- Transmit power: Low 0.5W, High 3.0W
- Modes: FM, NFM
- Bands: 136–174 MHz, 400–512 MHz
- Tone squelch: Cross, DTCS, TSQL, Tone
- Radio-wide settings, not just the channel list
GM-15Pro hardware
Researched from the sources listed below — spec sheets, manuals and retailer listings — rather than taken from the CHIRP driver. Anything not established is left out.
| Type | Handheld |
|---|---|
| Battery | 1500 mAh |
| Charging | USB-C |
| Transmit power | 0.5–5 W |
| Modulation | FM |
| Display | Yes |
| Still manufactured | Yes |
| Dual receive | No |
| Cross-band repeater | No |
| APRS | No |
| GPS | No |
| Bluetooth programming | No |
Frequency bands
| Band | Receive | Transmit |
|---|---|---|
| VHF | 136–174 MHz | — |
| UHF | 400–512 MHz | — |
| GMRS | 462.55–467.725 MHz | 462.55–467.725 MHz |
GMRS radio; VHF and UHF are scanner receive only.
Sources: baofengradio.com
Can I update the firmware on the GM-15Pro?
Baofeng publishes no firmware update for the GM-15Pro: its radios are programmed at the factory, and their firmware is not meant to be replaced. Its download area carries programming software and manuals; the two radios that do have firmware are listed separately here.
Baofeng downloads at baofengradio.com
WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.
How to program a Baofeng GM-15Pro
- Plug the programming cable into the radio and the computer.
- Open WebCHIRP, check Baofeng GM-15Pro is selected, and press Download.
- Edit the channels, or pull in nearby repeaters from a directory.
- Press Upload to write the result back to the radio.
Questions
Do I need to install a USB driver to program the Baofeng GM-15Pro?
No. WebCHIRP talks to CH340, CP2102, PL2303 or FTDI programming cables from the browser, so there is nothing to install on Windows, macOS or Linux.
Do I need the Baofeng CPS software?
No. WebCHIRP runs CHIRP's own Baofeng GM-15Pro driver in the browser, so it reads and writes the same codeplug the desktop software does.
How many channels does the Baofeng GM-15Pro hold?
250, numbered 1 to 250 in the channel table.
Can I update the firmware on the Baofeng GM-15Pro?
Baofeng publishes no firmware update for the GM-15Pro: its radios are programmed at the factory, and their firmware is not meant to be replaced. Its download area carries programming software and manuals; the two radios that do have firmware are listed separately here. WebCHIRP does not flash firmware. It reads and writes the channel list and settings over the programming cable, which is a separate part of the radio.